Powered by MRS Technology

CyberGage®360

Unprecedented combination of speed, accuracy and one-button simplicity for non-contact automated 3D scanning inspection.

Make an Inquiry
Make an Inquiry

Dramatically Speeds Up Quality Assurance of In-Process Inspection and/or Incoming/Outgoing parts inspection; Lowers Cost of Quality & Speeds Up Product Time-to-Market.

High-Precision accuracy with Multiple Reflection Suppression (MRS) Sensor Technology

Generates an automated, highly precise, full 360⁰ volumetric scan with NIST traceable accuracy to 7 µm + L/10000.

Incorporates CyberOptics’ proprietary 3D Multi-Reflection Suppression (MRS) technology that enables metrology-grade accuracy by inhibiting optical measurement distortion and reflections.

Easy-to-use Software with Push-Button Automation

Simplifies scanning with one-button simplicity

Provides factory-friendly operation with minimal training

Generates automated inspection reports including a comparison of scan data to CAD models or models based on ‘golden’ examples.

Programs off-line with pre-defined inspection templates

Speeds part program selection with Bar Code Part ID

Eliminates inspection gages with fixtureless design

Offers quick and simple field recalibration

Automated 3D Volumetric Part Scan and Inspection Report in less than 3 minutes

Quickly generates a highly precise, full 360⁰ volumetric 3D surface scan of complex shaped parts in <3 minutes

Facilitates near-production line high-volume scanning and high speed throughput

Full 360° Scan

Designed for use in general purpose metrology, the CyberGage®360 has a range of applications from medical to automotive to aerospace to consumer electronics, where high accuracy and high speed throughput are important.

Work Volume

8” x 4” (Cylinder 200mm diameter x 100 mm high)

System Configuration

MRS Sensor technology with 2 scanners (1 above and 1 below)

System Volumetric Accuracy

7 µm; 0.007mm +L/10000mm (ISO 10360)

Repeatability

5 µm; 0.005mm/0.00020

Speed

16 million points/part/pose. Typical cycle time <3 minutes

*Specifications may change without notice.

1 Accuracy is the Maximum Permissible error of the measured length between 6 sets of sphere features, repeated 10 times. These distances vary in length from approximately 30mm to 150mm. Measurements are made utilizing CyberGage®360’s standard operating procedure, and include all potential hardware and software error sources.

2 Repeatability is the allowable 3 Sigma error of the measured diameter of a ring gage, repeated 10 times. Measurements are made utilizing CyberGage®360’s standard operating procedure, and include all potential hardware and software error sources.